Products - BUS BAR CHAMBER (ELECTRICAL)

Bus bar in an electrical power distribution is referred to thick strips of copper or aluminum that allows conduction of electricity within a switchboard, distribution board, substation, or other electrical apparatus. "Bus bar systems" is about conductors that take the form of a bar or bars of copper conductor where in bars may be exposed or enclosed. This system may be developed with one or more joints to ensure proper length and configuration with one or more take-off points connected to end-use equipment.

Since we understand the fact that the size of the bus bar is important in determining the maximum amount of current that can be safely carried; we therefore manufacture it precisely. Bus bars can have a cross-sectional area of as little as 10 mm² but electrical substations may use metal tubes of 50 mm in diameter (1,000 mm²) or more as busbars.

We manufacture busbars which are typically either flat strips or hollow tubes in accordance to the heat that has to be dissipated more efficiently due to their high surface area to cross-sectional area ratio. Hollow or flat shapes are prevalent in higher current applications as the skin effect makes 50-60 Hz AC bus bars more than about 8 mm (1/3 in) thick inefficient. A hollow section has higher stiffness than a solid rod, which allows a greater span between bus bar supports in outdoor switchyards.

Cited below are some of the features of our bus bars are as follows:

  • Fulfills the safety parameters
  • Corrosion Free
  • Durable
Available with :
  • 32 Amps
  • 63 Amps
  • 100 Amps
  • 200 Amps
  • 320 Amps
Celling Fans Exhaust Fans Fresh Air Fans
Mono Block Pump AC Power Plug Box Distribution Boards (MCB)
Bus Bar Chamber (Electrical) Phase Changer (MCB) Main Switch
Modular Boxes Change Over Switch Cable Trays (Powder Coated/G.I.)
Kit Kat Fuse Concealed Metal Box Fan Box
Home | About Us | Products | Contact Us
Web site design and maintained by SIGMA PLUS INFOTECH
eXTReMe Tracker